Many masters will say: Bringing a rhinestone will be very troublesome, but also more investment, directly that hammer on the hole opener is light and convenient.In fact, because the power of the hammer is small, without a clutch, it is easy to get stuck, suffocate the hammer, so the use of a single hammer life is certainly not as good as the rhinestone plus hammer.
Share your tips for dry rhinestones here.
When you start drilling, the drill bit should not be drilled straight. First, grind the wall diagonally. Be careful not to have a…
Press the switch, to press, release, use the inertia of the power outage to grind the wall, when the wall grinds a crescent-shaped groove, the drill bit can be slowly straightened until it is completely ground into a circle, when grinding into a circle can press the switch, appropriate force pressure.Note that there is a shoulder rest on the back of the rhinestone. Make sure it is close to your shoulder. Your hand is only responsible for switching and holding it in place. Downforce should be close to your shoulder
Under the arm pressure, when drilling to a certain depth, to pull out the drill bit insert, this action you should be familiar with, is to pull out, do this is to pull out the powder inside, do not increase the friction of the drill bit, when you feel the drilling down speed is very slow, please pull out the drill bit to see if there is any broken brick or cement wall skin inside.When you are about to open, pay attention to reducing the downforce, so as not to rush out, or break a piece of the outer wall.
The above is the dry drilling method, we will continue to introduce our other best-seller products.
Post time: Feb-22-2023